1

Prepare the Surface

Ensure the installation surface is clean, dry, flat and structurally sound. Remove dust, loose material, grease and surface contamination.

2

Measure & Plan

Measure the installation area and mark the panel layout before cutting or fixing.

3

Cut to Size

Cut the panel to the required dimensions using suitable tools. Use a fine-tooth saw for timber sections and a sharp utility knife where suitable for the flexible backing.

4

Apply Adhesive

Apply suitable construction adhesive evenly to the rear of the panel, following the adhesive manufacturer's instructions.

5

Position & Press

Place the panel onto the wall, check alignment with a spirit level and press firmly into position.

6

Align Adjacent Panels

Install the next panel carefully so the spacing, direction and pattern remain consistent.

7

Finish the Edges

Trim visible edges and complete corners or transitions for a clean finished appearance.

Tools

Tape Measure | Pencil | Spirit Level | Suitable Saw / Cutting Tool | Utility Knife (if applicable) | Construction Adhesive | Caulking Gun | Roller or Spray Equipment for Final Paint Finish

Routine Cleaning

Use a soft dry cloth or lightly damp soft cloth to remove dust and light surface marks.

Indoor Use

Use as an interior decorative panel unless your actual product has been specifically tested and approved for other environments.

Moisture

Avoid prolonged exposure to standing water or excessive moisture unless the finished system is specifically rated for those conditions.

Finished Surface

After painting, follow the selected paint manufacturer's cleaning and maintenance instructions.