Care and Maintenance

Line positioning:

Draw horizontal and vertical lines on the wall to determine the installation position of the wallboard.

Wall surface treatment:

Clean the wall surface to ensure that it is flat, clean, oil-free and dust-free.

Back slurry scraping:

Evenly apply adhesive on the back of the wallboard to ensure that the slurry rate reaches more than 90%.

Adjust the gap width:

Adjust the gap width between the wallboards according to the design requirements and compact it with a large rubber plate.

Joint treatment:

Use plastic wedges or caulking glue to fill the gap, or use silicone glue to fill the gap.

Joint pulling treatment:

When the caulking agent is half dry, use a hacksaw blade to pull the gap to ensure that the gap is deep, saturated and smooth.

Cleaning treatment:

Use a knife to scrape the areas contaminated by adhesive and grout.

Use a dry sponge to remove excess adhesive and dust.

Precautions:

Use anti-alkali adhesive to paste.

Use matching caulking agent to point the joints.

If the adhesive is contaminated during the process, do not wipe it wet, and use a trowel or dry sponge to remove it when it dries.